The beauty of the C5 control series is its simplicity. All the components from the relays to the fuses are located right on the board. This is nothing new, except that the C5 series accomplishes this without having high voltage run through the board. With this unique design, you get the convenience of an all-in-one board with the safety and longevity of low power electronics. This control system is set up for a 240v power supply. The control come standard with primary and secondary pumps wired for 240v, light is wired for 12v, and all other components (blower, ozone, circulation pump, stereo/aux) is wired for 120v. Voltages of these controls may easily be changed by moving the neutral wires at the power block in the control as needed. (see instruction manual for wiring configuration)
This Control System Can Operate the Following:
1- Pump #1 120v/240v 2 speed
1- Pump #2 120v/240v 2 speed
** or **
1- Pump #2 120/240v 1 speed
** and **
1- Air Blower 120v/240v
** or **
1- Pump #3 120v/240v 1 speed
1- Ozonator 120v/240v
1- Audio/Aux 120v/240v
1- 12v light
- 1 Speed Aux Ready (Pump #3 or Blower)
- Circ. Pump Ready
- 12v Spa Light Ready / Cord included
- Ozone Ready
- Flo-Thru Stainless Steel Heater
- Thermowell for thru wall applications
- 120 volt transformer is included
Dimensions:
- 13" Tall
- 19" Wide
- 6" Deep
T7 Topside Dimensions: 5" x 2.5"
The T7 Topside
The T7 Topside control comes standard with every C5 control system sold, and can be programmed for almost any spa's configuration. From a spa with a single pump and light, to a spa with a circulation pump, two booster pumps, air blower, ozonator, fiber optic lighting, and an entertainment system.
The new T7 topside features a unique design that allows the installer to install the unit by simply drilling a 1-3/4" hole instead of needing to cut a rectangle out in the spa out with a jig-saw.
Programming the T7 topside is simple and all done using the keypad. The T7 doesn't need a battery to remember it's settings. On-board flash memory makes sure that once a topside is programmed, it stays that way regardless of power status.
Safety, built-in
The C5 series of controls are one of the industrys first controls to be fully tested and approved under the latest editions of UL testing requirements for the United States, and CSA testing requirements for Canada.
Spa Control Systems should be installed by a licensed electrician, Hot Tub repair technician or individuals with the basic knowledge of electrical safety and knowledge of electronics.